Dynamic Recrystallization by Necklace Mechanism During Hot Deformation of 316 Stainless Steel

Document Type : Research Paper

Authors

Department of Materials Engineering, Isfahan University of Technology,.Isfahan, 84156-83111, Iran

Abstract

The aim of this study is to investigate the nucleation of new grains by necklacing mechanism during dynamic recrystallization (DRX). The material used is 316 stainless steel. In order to modeling the deformation behavior during hot rolling, one-hit compression tests were performed at temperature range of 950-1100 °C with strain rates of 0.01-1s-1. The result shows that at the temperature of 1000 °C with the strain rate of 0.1 s-1, DRX developed by necklace mechanism, it is far from completeness over the steady state stress. By contrast the hardness increased by development of DRX. The final microstructure is very heterogeneous and comprises of very fine and coarse grains due to the occurrence of partial DRX. The results also show that the necklace structure developed by increasing Zener-Hollomon parameter (Z).

Keywords

References

[1] H. J. McQueen andC.A.Imbert, J. Alloy Compd. 378(2004), 35.
[2] A. Belyakov, Mater. Sci.Eng.A, 255(1998), 139.
[3] D. J. Towel, Metal Sci. (1979), 246.
[4] D. Ponge and G. Gottestein, Acta Mater., 46(1998), 69.
[5] W. Roberts, H. Boden and B. Ahblo, Metal Sci. (1979), 195.
[6] Sumantra Mandal, P. V. Sivaprafab, R. K. Dube, International Symposium of Research Students on Material Science and Engineering, (2004), 20-22, Chennai, India.
[7] J. J. Jonas, E. I. Poliak and A. Najafizadeh, Thermec 2006 Vancouver, Canada, Materials Science Forum, (2006), 100.
[8] H. J. McQueen, Mater. Sci.Eng.A, 387–389 (2004), 203.
[9] M. C. Mataya, " Metal. Trans. A, 21(1990), 1969.
[10] A. Belyakov, Mater. Sci.Eng.A, 319–321 (2001), 867.
[11] W. Roberts, Metal Sci., (1979), 195.
[12] G. R. Stewart, J. J. Jonas, ISIJ Int., 44(2004), 1581.
[13] A. Najafizadeh and J. J. Jonas, ISIJ Int., 46(2006), 1679.
[14] R. Ebrahimi and A. Najafizadeh, J. Mater. Process. Technol. 152(2004), 136.
[15] Sung-Il Kim, Mater. Sci.Eng.A, 311(2001), 108.
[16] M. El Wahabi, Mater. Sci.Eng.A, 343(2003), 116.
[17] Sung-Il Kim, Mater. Sci.Eng.A, 357(2003), 235.
 
International Journal of Iron & Steel Society of Iran
Volume 4, Issue 1 - Serial Number 1
December 2007
Pages 16-23

Files

Share

How to cite

Statistics